How To Install Rgb Lights In Pc

Download Commodity

Download Article

If y'all've e'er wanted to add some illumination to your killer gaming rig, we can show you how. By far, this is arguably the easiest and safest manner to do and so. Every bit e'er, you're doing this at your own take chances. Nosotros aren't held responsible for anything that may happen to your property. Practice caution and condom at all times. Scroll downwardly to step 1 to begin.

Steps Download Article

i
Have out your Case's left side panel and clean it.
- Carefully unscrew the rear screws that hold your PC'south side panel on to the master case.
- Slide it back and accept information technology out.
- Appraise the inside of the panel and see which parts you want to stick the LED strips on.
- In one case you've chosen the part, get some tissue paper and moisture it with booze.
- Rub the surfaces of the inside panel to remove grit, oil or any other substances that will forestall a great stick.
2
Cut out the LED strips and secure them in place.
- Measure out and cut the strips to size. Near strips allow y'all to cut merely every subsequently 3 LEDs, and so keep that in mind.
- Peel the back of the strips and lay them into the panel.
Advertisement
3
Connect the strips in a parallel.
- Measure and cut the wire to connect the strips in a series. Add a picayune allowance, equally you volition accept to utilize wire stripper to take the insulator off the ends of the wires.
- Using the soldering gun, connect the wires to the strips. Make certain that the diodes (+/ -) are correctly connected. Most wires are color coded so you are less likely to make the error of connecting the positive diodes to the negatives. White or Black is positive and whatever else color should be the negative.
- Apply the hot glue to secure the wires to proceed them from moving effectually in the case.
4
Splice the LED strips into the MOLEX connector.
- The first finish of the flexible LED strips should come with a pair of wires to connect power to. If not, then solder two wires to the positive and negative terminals.
- Grab your MOLEX connector. The Yellow wire is 12V, and the black is footing. Cull a connector you want to employ as the place where y'all splice the connection. The connector end where the two branches come across is what you plug into the power supply.
- Use the wire stripper to split the black and xanthous wire.
- Solder the black wire (basis) from your MOLEX connector to one wire from your strip assembly.
- Practice the same for the other wire.
- Secure the connections past using some electric tape.
5
Plug in the MOLEX connector to a vacant male person MOLEX connector from your power supply.
- Locate a vacant male person connector from your ability supply to connect to your strip associates. When you power your estimator on, it should calorie-free up.
vi

Finished.

Advertising

Add together New Question

Question

On the Molex female connector, what practise I exercise with the red and relevant blackness ground wire?

Just leave it if you don't mind, and likewise if you don't want the actress cables, you can always pull them out by squeezing the metal pins. If that is too hard for you lot, y'all can always cut them off.
Question

I have four colored wires in my LED strip: yellow, green, blue and crimson. Which color do I connect to which?

It sounds like you have a multicolor RGB (red green blue) led strip. In that instance, connect the yellow wire to the positive voltage line. If you connect the green wire to basis, the strip will glow green: the aforementioned goes for blueish and ruby.
Question

Is in that location any way to control the timing or movement of the lights?

You can using a micro-controller such as an Arduino or Raspberry Pi. You tin can apply this in conjunction with an audio input from your PC and have the code configured accordingly.
Question

Can I add the lights before building the actual PC?

Every bit long as the lights are continued to your power supply as shown, it shouldn't matter when you apply the lights.